wiznet
– Support for WizNet hardware, including the WizNet 5500 Ethernet adaptor.¶
Warning
This module is disabled in 6.x and will removed in 7.x. Please use networking libraries instead.
-
class
wiznet.
WIZNET5K
(spi: busio.SPI, cs: microcontroller.Pin, rst: microcontroller.Pin, dhcp: bool = True)¶ Wrapper for Wiznet 5500 Ethernet interface
Create a new WIZNET5500 interface using the specified pins
- Parameters
The reset pin is optional: if supplied it is used to reset the wiznet board before initialization.
The SPI bus will be initialized appropriately by this library.
At present, the WIZNET5K object is a singleton, so only one WizNet interface is supported at a time.
-
connected
:bool¶ (boolean, readonly) is this device physically connected?
-
dhcp
:bool¶ (boolean, readwrite) is DHCP active on this device?
set to True to activate DHCP, False to turn it off
-
ifconfig
(self, params: Optional[Tuple[str, str, str, str]] = None) → Optional[Tuple[str, str, str, str]]¶ Called without parameters, returns a tuple of (ip_address, subnet_mask, gateway_address, dns_server)
Or can be called with the same tuple to set those parameters. Setting ifconfig parameters turns DHCP off, if it was on.